AEROSPACE

Customer Pain Points

  • Needs to test the actual deliverable composite part
     

  • Needs Non-Destructive (NDT) inspection capabilities
     

  • Needs real time & tighter In-process Quality Control

    • Determining Composite material variability & uniformity

    • Product cure verification of anisotropic material

  • Needs to reduce scrap/waste while increasing production efficiencies

  • Needs real-time Material EM Properties / Characterization

    • In liquid / resin state

    • In powder state

    • In-process high temp. conditions

    • In solids; pre or post “cooking”
       

  • Needs to inspect for defect;

    • Moister Levels

    • Surface; dents, strikes, F.O.D.

    • Composite material repair quality

Customer Benefits

Customer proven results from implementing our QA/QC system

  • Received real-time controllability

    • At frequency of interest

    • Line speeds >300 ln.ft./min.

  • Increased process uniformity by >52 %

  • Reduce scrap rate by 80%

  • ROI of $380K system was <4 months

   

‌Typical Manufacturing Results

  • Increased Production Efficiencies by 60%

  • Increased Production Speeds by 3x (40 to 120 ln.ft/min.)

    • (>6x is achievable)

  • Reduced Scrap & Waste by 80%

  • Eliminated Sample Preparations & Machining / Fabrication

  • Reduced Labor Requirements

  • ROI: 2 to 6 Months (application dependent)

More information coming in 2021.

Please fill out information below to contact us for more specific details to meet your needs.

arrow&amp;v
OPENING HOURS
ADDRESS
GET IN TOUCH

Mon - Fri: 7am - 4pm

​​Saturday: By appointment only 

​Sunday: By appointment only

1002 E Vista del Cerro Drive

Tempe, Arizona 85281

Mailing:

PO Box 10526

Tempe, AZ 85284

480-773-7100

info@mwilab.com

  • LinkedIn

© 2020 by MWILabs